Wind Power heat exchanger,oil cooler,wind turbine heat exchanger:
The plate bar oil cooler and water cooler are widely applied for cooling 0.8MW to 7MW system of gearbox, converter, converter cabinet, generator system, nacelle and so on.
Feature:
Wind power is one of the most cost-effective and rapidly growing renewable energy technologies available. The world’s windmills already produce 13,000 MW of electrical power, and experts consider that some 10% of the world’s energy demand could be supplied by wind power in the future.
Choose anodic oxidation and electrophoresis surface treatment, which is widely used for offshore wind power
Corrosion-proof grade: C5
Corrosivity resistant level: ISO12944 C3/ C4/C5-I/C5-M.
An ideal application for Wind Power heat exchanger
There is an ideal application for ORCAER’S rugged and efficient brazed plate heat exchangers in every windmill: not directly in the production of electricity, but for cooling the vital oil that lubricates the mechanical power transmission and control systems.
A gearbox at the top of the windmill controls the velocity of the rotor and transmits mechanical power. The transmission oil that lubricates the gears gets hot, and must be cooled to maintain its performance and protect the gearbox. In a single-circuit solution, the oil is cooled by being pumped through a large air coil. However, this requires a large, expensive pump and air coil, and is neither efficient nor convenient, particularly when windmills are typically located in exposed and/or remote positions.
Generally improved heat transfer
Cooling performance can be improved cost-effectively and within a smaller envelope by using a ORCAER brazed plate heat exchanger, The brazed plate heat exchanger solution replaces the single large oil circuit with two smaller circuits, one for oil and one for ethylene glycol, with several advantages.
Heat transfer generally is improved because of the highly turbulent flow through each brazed plate heat exchanger. Furthermore, the pumps and the air coil required for the two-circuit solution are smaller and less expensive to buy and run.
This is because ethylene glycol has better heat transfer properties than lubricating oil, and this system requires less ethylene glycol to flow through the air coil.
During operation, the temperature of the transmission oil increases, and must be reduced to maintain proper lubrication of the gearbox. The oil is pumped through the brazed plate heat exchanger where it is cooled by a glycol/water solution.
The glycol/water solution is cooled in turn by passing it through a relatively small coil fitted with flanges that present a large area to the air for cooling.
Benefits
In this solution, ORCAER brazed plate heat exchangers offer:
High efficiency even at low flow rates
Savings on buying and operating pumps and air coils
Ruggedness and simplicity for minimal maintenance
Compactness for lower overall space requirements
Generator cooling
Radiator for generator, converter and inverter cooling
Contact us for further technical details and configuration options.
